TURBO-PROG supports two types of turbo actuators:
For Hella actuators TURBO-PROG allows the user to:
The term 'actuator parameters' means the following information:
For Siemens actuators TURBO-PROG allows the user to:
1. program range of operation of geometry lever (applies ONLY to the Siemens controller in a metal-plastic housing, Siemens controllers in a metal housing are not supported)
2. check range of movement of an actuator.
The programmer supports the following units:
- Hella actuators with the following markings:
- Siemens actuators in a metal-plastic housing used in turbochargers made for VW/Audi.
Link for download the update software:
Shipping cost depends on the country to which the products are to be sent and it is determined after choosing the products.